PiRelay – Raspberry Pi GPIO [Ad-Free]

SETUP INSTRUCTIONS: http://bit.ly/pirelay

PiRelay – The easy way to Switch Relays using the GPIO Pins on a Raspbery Pi (Control anything from 1 to 100 Relays connected to up to 5 RaspberryPi’s)

PiRelay is the original and best app for use with Raspberry Pi’s running the PiRelay software to Switch or Pulse the GPIO pins on up to 5 Raspberry Pi’s with Switch/Pulse control of up to 100 Relays/GPIO pins.

This app can be used to control virtually anything that uses an electronic switch to operate.

For example: Switch on/off Lights, open/close Electronic Garage Doors, open/close Gates, Unlock Doors, Control Heating, Cooling etc.. Anything you can think of that you might want to control, if you can wire it up, PiRelay can control it.

**\ Share a YouTube Video of your Project //** – Use keyword: PiRelayApp to share your creation with the PiRelay community.

IMPORTANT NOTE: You must follow the instructions to install PiRelay onto your Raspberry Pi before this app will work.

TALİMATLAR: http://bit.ly/pirelay

Ask questions in the PiRelay thread on the Raspberry Pi forum: http://bit.ly/RPiForumPiRelay

Features of PiRelay

– Control up to 100 Relays
– Use up to 5 Raspberry Pi’s
– Swipe down to refresh relay status
– Ability to send a pulse signal (i.e. Switch relay on then immediately off)
– Ability to assign Icons to relays
– Alternative On/Off Icons
– Refresh relay status
– Screen rotation
– Pi Header Diagrams for Rev1 (P1) & Rev2 (J8) boards
– Ability to change the Title Bar Name
– Ability to set the Wiring Pi Pin # used by each relay
– Free App (Ad Supported) with optional “In App Purchase” to remove ads

Ekran Görüntüleri

İndirmeler

PiRelay – Raspberry Pi GPIO v2.1.2 [Ad-Free] / Ayna